Smeg DWI614 User Manual

Page 8

SWITCHING OFF
The end of the washing program is signalled by a short intermittent beep and the

appearance of “P0” on the DISPLAY.

ANNULLING THE PROGRAM IN PROGRESS
To annul the program being carried out, after opening the door select program "P0".
When the door is closed the dishwasher will skip to the end of the program.

MODIFYING THE PROGRAM
To modify the current program, after opening the door select the new program.
When the door is closed the dishwasher will start the new program automatically.

DELAYING THE PROGRAM
The start of the washing program can be delayed from a minimum of 1 hour to a
maximum of 9 hours; this allows you to operate the dishwasher at the time of day of
your choice.

When the DELAYED START button (3) is pressed, the DISPLAY (7) will show first the
duration of the program set and then the number of hours (9,8, …1) of delay with which
it is to be started.

The

symbol will remain until the start of the washing cycle, while the number of hours

will disappear automatically if the keypad is not used for 5 seconds or if any other button

except the DELAYED START button (3) is pressed.
When the door is closed the dishwasher will perform a pre-wash, after which the
“program delay” set previously will start. To check the time left before the program
starts, simply press the corresponding button once.

If it is necessary to open dishwasher door during the washing cycle, there
will be a 1-minute delay before the program can be resumed.
After correctly closing the door, the washing program will start again from
where it was interrupted. This operation may negatively affective the
progress of the washing cycle.

TABLE FOR CERTIFICATION BODIES

Reference standard

EN 50242

Reference program

(*) BIO program (5)

Load

14 place-settings

Type of detergent

Amount of detergent

30 g

Rinse aid setting

Depending on the model 3/4 or 4/6

EN 50242 STANDARD LOADS

LOWER BASKET

UPPER BASKET

The cutlery basket disposes of an exclusive system of indipendent sliding flap
inserts; some combinations permit to make the best of the available space.

Vertical

inserts

Horizontal

insert

open

Horizontal

insert closed

Movement required

to extract the inserts