Stiga 8211-0288-01 - Manual (Page 7)

7
ENGLISH GB
The towing unit must only be loaded with a verti-
cal force of max. 100 N.
The pulling force on the tow unit from towed ac-
cessories must be max. 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.
STARTING AND OPERATING
ENGINE CASING
The engine casing must be removed to inspect and
maintain the engine and battery. Removing:
1. Lift up the two catches on the rear edge (fig. 4).
2. First pull the engine casing backwards slightly.
Then lift it off.
Fitting:
1. Tilt the seat forward.
2. Align the casing’s top front pegs to the recesses
in the front of the engine casing (fig. 5). Do not
push the pegs in yet (see item 4 below).
3. Place the casing’s bottom pegs in the groove in
the shock absorber.
4. Guide in the two side pegs in the groove in the
front engine casing. Now press forward the
complete casing.
5. Finally, push down the two catches.
The machine must not used without the
engine casing fitted. Risk for burn inju-
ries and pinch injuries.
FILLING THE FUEL TANK
Always use clean unleaded petrol. Never use oil-
mixed 2-stroke petrol (fig. 6).
NOTE! Bear in mind that standard unleaded petrol
is perishable. Never purchase more than what you
can use within 30 days.
Environmentally-friendly petrol is a good choice
of petrol. This type of petrol has a composition that
is less hazardous for people and nature.
Petrol is highly inflammable. Store pet-
rol in specially made containers for this
purpose.
Only fill up with petrol outdoors, and
never smoke when filling. Fill up with
petrol before starting the engine. Never
remove the filler cap or fill up with pet-
rol when the engine is running or still
warm.
Never completely fill the fuel tank. Leave an emp-
ty space (= at least the entire filler tube plus 1 - 2
cm at the top of the tank) to allow the petrol to ex-
pand when it warms up without overflowing.
CHECKING THE OIL LEVEL
(Master - Senator - Comfort - Presi-
dent)
On delivery, the crankcase is filled with SAE 30 oil.
Check the oil level every time before using to
ensure that it is correct. The machine should be
standing on level ground.
Wipe clean round the oil dipstick. Release
it and pull out. Wipe, push down fully and
screw it back in.
Unscrew it and pull out again. Check the oil level.
Top up with oil to the “FULL” mark if the oil level
is below this (fig. 7).
CHECKING THE OIL LEVEL (Royal)
On delivery, the crankcase is filled with SAE oil
10W-40.
Check the oil level every time before using to
ensure that it is correct. The machine should be
standing on level ground.
Wipe clean round the oil dipstick. Release
it and pull out. Wipe, push down fully
without screwing it back in.
Pull out again and check the oil level. Top up with
oil to the “FULL” mark if the oil level is below this
(fig. 8).
SAFETY SYSTEM
This machine is equipped with a safety system that
consists of:
- a switch at the gear lever (only Master, Senator,
Comfort).
- a switch at the brake pedal (only President,
Royal).
- a switch in the seat mounting (all).
In order to start the machine, the following are nec-
essary: