Sirius Satellite Radio ESR-T100 - Manual (Page 11)

10
6. SIRIUS OPERATION
Selecting SIRIUS SATELLITE RADIO modes
Press the [MOD] button to select the SIRIUS mode. The SIRIUS indication lights
up when SIRIUS mode is selected.
Notes:
• The [MOD] button selects the external devices connected to the source unit in
order, for example: AM/FM mode AUX mode SIRIUS mode CD changer
mode etc.
Selecting a band
Press the [BND] button to select a band. Each press of the button changes the
display as shown below.
S1
S2 S3 S1 …
The currently received band is displayed in the function mode indication.
Models without a function mode indication display the band name and channel
number in the display.
Information displayed during reception
The following information is displayed when SIRIUS Satellite Radio cannot be
received normally.
• UPDATING: when the receiver is turned on the first time or after a reset. Do not
turn power off during this time as the receiver is downloading the channel guide.
• LINKING: when there has been a temporary loss of signal and the receiver is
attempting to reacquire a signal. (“LINKING” is shown on an 8-digit display)
• INVALID/ CHANNEL: a channel without a broadcast has been selected
(Message “INVALID” or “CHANNEL” is shown on an
8-digit display)
• CALL 888/ 539-SIRI: a channel not available in your subscription
(Message “CALL 888” or “539-SIRI” is shown on the
display)
• NO ANT: no antenna is connected or there is a problem with the antenna
Switching the display
1. Press the [DSP] button to select the desired display.
The main display or the clock display appears each time you press the [DSP]
button.
2. In the main display, press the [DSP] button to cycle between the following
display modes:
Channel name
song title artist name category name time channel
name …
Notes:
• The display shows the abbreviated channel name for 2 seconds when a station is
selected before returning to the chosen display mode.