Swisher AZ Series - Manual (Page 9)

7
3. CHECKING THE ENGINE
The engine has been serviced prior to ship-
ment. However, it is important to check
the oil level prior to starting the engine.
If more oil is required, follow the engine
manufacturer recommendations. Be
careful not to overfill.
IMPORTANT! GASOLINE SHOULD
BE ADDED OUTSIDE IN
A WELL VENTILATED AREA.
Add approximately one gallon of fuel to
the tank. Be certain to follow the engine
manufacturers recommendations on the
type of fuel to use.
The gearbox is filled with lubricant at the
factory. However, verify that the gearbox
is filled by removing the Oil Check Plug
(Part #T143P) located on the side of the
gearbox.
The lubricant should be level with the oil
check plug opening.
If you need to add lubricant, use ONLY
TR125L, which is specially blended by
Swisher Mower and Machine Company.
4. ADD GASOLINE
5. CHECKING GEARBOX LUBRICANT
The seat should be installed using the two
(2) bolts and lock nuts supplied.
Attach the wiring from the mower to the
seat safety switch. Important! The wir-
ing must be connected to the seat safety
switch for the mower to operate.
On 12 volt models:
attach green wires
and the brown wires to the two (2) remain-
ing positions on the safety switch.
On non-l2 volt models:
attach the two
(2) brown wires to the safety switch.
The order of wire attachment or position
does not matter.
Attach the grass chute using the bolt, nut
and spring supplied. Important! Do Not
operate without the grass chute in place!
6. INSTALLING THE SEAT
7. INSTALLING THE GRASS CHUTE (for
non-mulching mowers only)
•
•
•
•
•
•
•
•
•
•
•
•