Sunbeam Electric Heater - Manual (Page 10)

FINAL ART 5/5/05
& Associates, Inc. Job # 0023671 Size:10.75" x 8.25" (PAGE 5.375" x 8.25") Art Built @ 100% PAGE SIZE Colors: B/W
8 For questions or support, please visit: www.sunbeam.com
Q My heated blanket/heated mattress pad/warming throw doesn’t heat properly.
A Your warming product is not a heating pad. It will not feel hot to the touch when laid out
flat in a normal manner. Try the following fold test to see if it is operating properly:
1 Fold the heated blanket, heated mattress pad or warming throw 3 times over.
2 Make sure the control cord is connected to the module and then
plug the power cord into an outlet.
3 Turn on your warming product, then turn the control to the highest
setting and wait 5 to 7 minutes.
4 Put your hand between the folds and you should feel the blanket/
mattress pad/throw warming up.
Caution: DO NOT continue the test for more than 7 minutes. DO NOT
attempt to make any internal adjustments to this appliance. If you have tried all of the
solutions above and the warming product still doesn’t work, stop using it immediately,
disconnect the power cord and contact Sunbeam Consumer Care.
Q What does “FF” mean on my Electronic Digital Control?
A The digital controls are designed to notify you in the event that a problem has been
discovered by flashing “FF” on the display. Follow instructions on the flag tag to reset
control. First, check the blanket/mattress pad for visual damage. If no visual damage
is found, unplug the system from wall outlet. Check that the control is
well-connected to the module. Plug the power cord into the wall outlet.
Set the control to “On.” If the system still does not operate after 2 or 3
times trying to reset, disconnect the power cord and contact Sunbeam
Consumer Care.
Q What does a flashing light mean on my EasySet™, SlimStyle™ AO or
SlimStyle™ control ?
A These controls are designed to notify you in the event that a problem has
been discovered by flashing the light on the control. Follow instructions on
the flag tag to reset control. First, check the warming product for visual damage.
If no visual damage is found, unplug the system from wall outlet. Check that the
control is well-connected to the module. Plug the power cord into the wall outlet
and turn the control On. If the product still does not operate after 2 or 3 times
trying to reset, disconnect the power cord and contact Sunbeam Consumer Care.
FF
Models:
ViewEasy™,
ChoicePlus™,
StyleSmart™,
SmartSense™