Steamfast SF-407 - Manual (Page 8)

8 | ENGLISH
CONNECTING HOSE
1. Place end of Hose onto threaded Hose Base (FIGURE 5-A).
2. Rotate coupling in clockwise direction until Hose is tightly secured onto Hose Base
(FIGURE 5-B). Hand tighten only. Do not over-tighten.
3. Hang Steam Nozzle on specially designed Steam Nozzle Cradle (FIGURE 5-C).
CAUTION: To prevent steam from causing bodily injury or damage to surfaces, always hang
Steam Nozzle on Steam Nozzle Cradle when not in use. Do not lay Hose on the floor as
condensation may build up, causing unwanted water droplets in the steam. Do not pull on
the Hose with excessive force as this may damage it, resulting in a steam leak.
CONNECTING FABRIC BRUSH
1. Make sure Lighted On/Off Switch is set to “OFF” position, and
that unit is not emitting any steam.
CAUTION: Do not try to connect Fabric Brush while unit is
emitting steam, as this can cause burns and injury.
2. Align the four pegs on back of Fabric Brush (2 circular and 2
elliptical) with corresponding holes on face of Steam Nozzle.
3. Press Fabric Brush firmly onto Steam Nozzle, until it fits snugly
and firmly in place (FIGURE 6).
Your new SF-407 Everyday Fabric Steamer is now fully assembled and
ready for use. Please continue reading this manual for instructions on
using the Everyday Fabric Steamer, as well as directions for proper
cleaning, storage and troubleshooting.
Assembling Your
Everyday Fabric Steamer
FIGURE 6
FIGURE 5
5-A 5-B
5-C