Standard Horizon Hx750s - Manual (Page 33)

Page 33 HX750S
04 tEP (TEMP ADJUST)
Function: Calibrating the Thermometer setting
Available Values: –9.9 ~ +9.9
Default: 0.0
See page 31 for details.
05 LP (LAMP MODE)
Function: Selects the Lamp illumination method for the LCD/
Keypad.
Available Values: Cnt / kEY / off
Default: kEY
kEY: Illuminates the LCD/Keypad for 5 seconds when any key is pressed.
Cnt: Illuminates the LCD/Keypad continuously.
Off: Turns off the backlight for the LCD and keys.
06 dr (DIMMER)
Function: Adjusting of the display brightness
Available Values: 00 / 01 / 02 / 03
Default: 02
07 SnL (SCAN LAMP)
Function: Enable/Disable the automatic illumination of the
lamp when a signal is received on a channel during Scan-
ning
Available Values: on / oFF
Default: oFF
08 SCn (SCAN DISPLAY)
Function: Selects the Scanning display mode
Available Values: nor (Normal) / SPL (Special)
Default: nor (Normal)
When this menu is set to “nor (Normal)”, the channel numbers during scan will
be shown as scrolling on the display. When “SPL (Special)” is selected the
channel numbers on the display do not change unless a call was received.
The channel shown is the last channel that was received.
09 dt (DUAL WATCH MODE)
Function: Selects dual or tri-watch as desired.
Available Values: d- (Dual Watch) / t- (Triple Watch)
Default: d- (Dual Watch)
See page 27 for details.