Smeg LSP1449B - Manual (Page 18)

User instructions
17
To set the delay once the program has started, proceed as follows.
If the program you wish to carry out is the same as the one already
in progress:
• press
the START/PAUSE button (5) for a few seconds, until the
PHASES/PROGRAM lights (10) come on;
•
annul the program in progress (see relative section) and wait for the
cycle to come to an end;
•
select the program again;
•
select the delay required;
• press
the START/PAUSE button (5) to start the new program.
If the program you wish to carry out is different from the one
already in progress:
• press
the START/PAUSE button (5) for a few seconds, until the
PHASES/PROGRAM lights (10) come on;
•
change the program;
•
select the delay required;
• press
the START/PAUSE button (5) to start the new program. The
dishwahser will pump out the water and restart with the delay set
and the new program.