Spalding 211230 - Manual (Page 8)

8
ID# 211230 04/06
2.
IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
3
4
MIDDLE
BOTTOM
alignment mark
Align poles using alignment marks. Pound
middle and bottom poles together by bouncing
them on a scrap piece of wood on the ground
as shown in FIG A. until they no longer move
toward pole identification stickers.
FIG A.
scrap wood
(Not Supplied)
bottom pole
IDENTIFICATION
STICKER
bottom pole
IDENTIFICATION
STICKER
3-1/2"
1-1/4"
THE IDENTIFICATION STICKER IS
LOCATED 3-3/4" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 2-1/2"
MINIMUM OVERLAP, LEAVING 1-1/4"
BETWEEN THE OVERLAPPING POLE
AND THE IDENTIFICATION STICKER.
CAUTION!