Star Micronics SP298 - Manual

Removing the protective materials
Four protective materials are inserted into the printer to protect components during
shipping. Before using the printer, be sure to remove all protective materials as
shown in the illustration.
❏
Remove the two pieces of protective tape.
❏
Pull the protective sheet straight out toward the front of the printer.
❏
Push in the side of the printer cover and lift it upward to remove it.
❏
Remove the packing materials.
Note that it is a good idea to keep all protective materials in case you will need to
pack the printer up again and send it somewhere at a later date.
SP298 80871055
Printer cover
Packing
material
Protective sheet
Protective tape
Protective tape
CAUTION