Troubleshooting continued, Problem cause correction loss of power, Excessive vibration – Swisher ZT2350A User Manual
Page 35: Engine backfires when turning engine off, Unit does not travel in a straight line
TROUBLESHOOTING Continued
PROBLEM CAUSE CORRECTION
Loss of
Power
1.
Cutting too much grass/ too fast
2.
“Choke” position
3.
Buildup of grass, leaves and trash under
deck.
4.
Dirty air filter
5.
Low oil level/dirty oil
6.
Faulty spark plug
7.
Dirty fuel filter
8.
Stale or dirty fuel
9.
Water in fuel
10.
Spark plug wire loose
11.
Dirty engine air screen/fins
12.
Dirty/clogged muffler
13.
Loose or damaged wiring
14.
Carburetor out of adjustment
15.
Engine valves out of adjustment
16.
Loose drive belt
1.
Set in High Cut (position 8)/reduce speed
2.
Push choke control in
3.
Clean underside of mower deck
4.
Clean or replace air filter
5.
Check oil level/change oil
6.
Clean and re-gap or change plug
7.
Replace fuel filter
8.
Drain fuel tank & refill tank with fresh gas
9.
Drain fuel tank & carburetor, refill tank with
fresh gas and replace fuel filter
10.
Connect and tighten spark plug wire
11.
Clean engine air screen/fins
12.
Clean/replace muffler
13.
Check all wiring
14.
See Engine Manual
15.
Contact an authorized service center
16.
Adjust idler/replace belt
Excessive
Vibration
1.
Worn, bent or loose blade
2.
Bent blade driver
3.
Loose/damage part or parts
4.
Faulty blade driver assembly
1.
Replace blade. Tighten blade bolt.
2.
Replace blade driver
3.
Tighten loose part or parts. Replace
damaged parts.
4.
Replace blade driver assembly
Engine
backfires
when turning
engine OFF
1.
Engine throttle control not set at “SLOW”
position for 30 seconds before stopping
engine.
1.
Move throttle control to “SLOW” position and
allow to idle for 30 seconds before stopping
engine
Unit Does
not
Travel in a
straight line
1.
Incorrect tire pressure
2.
Rear wheels rotating at different speeds.
1.
Check tire pressure (See Specifications)
2.
Adjust travel reduction weldment.
35
35