Sharp UX-P100 - Manual (Page 31)

Setting Up and Using OpenLCR
29
2. Setti
ng U
p
O
penLCR
Changing your user profile
If you need to change your user profile, pick up the handset on the fax
machine, and then press followed by . Follow the instructions you
hear.
♦
If the display shows the alternating messages SET OWN NUMBER / 10
DIGITS, press the number keys to enter your fax/phone number, including
the area code (the number must be 10 digits long). When finished, press
.
♦
If you are on a pulse dial line, press before pressing the number keys
to respond to the instructions. (This makes your fax temporarily issue tone
signals when you press the number keys.)
What to do if “E” appears in the display
A highlighted “E” will appear in the display in place of “C” if the rate data in the
fax is out-of-date and the fax is unable to obtain new data. When this
happens, OpenLCR routing will not take place.
OpenLCR
3
START/MEMORY
“E” indicates that the rate
data is out-of-date.
FAX TEL
JAN-19 02:16
This will only occur if the fax machine is unable for some reason to make its
periodic call to OpenLCR to receive new rate data.
First try downloading the rate data manually by pressing and as
explained in Downloading (receiving) the rate data manually on page 26. If
this doesn’t work, proceed to the following section, What to do if you cannot
connect to OpenLCR.
What to do if you cannot connect to OpenLCR
If you are unable to connect to OpenLCR when you use the OpenLCR key to
register or manually download data, it is likely that the phone number that the
fax machine dials when you press the OpenLCR key is no longer correct.
OpenLCR
2