Silvercrest STG 85 A1 - Manual (Page 7)

- 5 -
Start-up
Before commissioning, remove all paper and plastic
packaging from the appliance. Check to ensure that
the appliance is not damaged and the door closes
properly. Clean the inside of the appliance (see
chapter "Cleaning and Care").
Switching on
ƽ
Attention!
Wait at least 4 hours for the first start-up, so that the
coolant has re-amassed. If you do not, it would lead
to irreparable damage to the appliance!
1. Connect the appliance via the power cable with
a properly connected and earthed 230 V mains
power socket.
2. Bring the temperature controller 5 into the de-
sired position. The further you turn the regulator
clockwise, the lower the temperature will be in-
side the appliance.
• MIN = relatively low cooling
• = normal setting
• MAX = lowest temperature, maximum cooling
• The appliance will take about four hours to re-
ach the desired interior temperature. Please wait
this long until you start to fill the appliance with
frozen foods.
Note
The cooling temperature is influenced by, ...
• ... how high the ambient room temperature is,
• ... how much food is stored in the appliance,
• ... how you have set the appliance up.
Please take note of all of these factors when setting
the cooling temperature. Do not be afraid to experi-
ment a little to find out which cooling temperature best
suits your needs.
Note
With the "super freeze function" you can in a short
time set the maximum cooling performance. In this
case it does not matter at what level the temperature
regulator 5 is set.
Place the switch “Super Freeze” 4 at the ON posi-
tion if you want to cool the appliance down before
freezing fresh foods (see chapter "Freezing fresh
foods").
Always distribute the food to be frozen evenly in the
freezer compartments 8.
Later, do not forget to place the switch 4 back into
the OFF position.
Control lamps
• The operating control lamp (green) 3 glows
constantly when the appliance is connected to
the mains power supply. When you disconnect
the appliance from the power mains or there is a
power failure, then the lamp extinguishes.
• The temperature control lamp (red) 2 indicates
a temperature in the freezer compartment that is
too high. These may be the reasons for it:
- the appliance was just connected to the mains
power supply,
- a larger quantity of food is being stored in the
appliance than is admissible as given on the
typeplate,
- the appliance door has been left open for too
long,
- the temperature controller has just been turned
clockwise and the appliance has not yet
reached the desired temperature.
• The "Super Freeze" control lamp (yellow) 1 glows
when the "Super Freeze" switch is brought into
the ON position - the compressor then operates
continuously.
IB_STG 85 A1_49364_LB6 09.04.2010 14:10 Uhr Seite 5