Sterling Plumbing Roll-In Shower 62060103 - Manual (Page 2)

Installation Notes
Install this product according to the installation guide.
Drain cutout in subfloor to be 10-1/2 ″ (267 mm) per rough-in
illustration below to allow the backside of the drain to sit
below the subfloor surface.
Studs should be positioned as shown.
Backer boards and fasteners protrude beyond the back wall
1-1/2
″ (38 mm). If installing this product against wall board,
1-1/2
″ (38 mm) furring strips installed over the wall board are
recommended. The stud pocket depth of 40-5/8 ″ (1032 mm)
will need to be increased by the combined thickness of the
wall board and furring strips.
39-3/8"
(1000 mm)
1" (25 mm)
63-3/8" (1610 mm) Min
63-1/2" (1613 mm) Max
31-5/8"
(803 mm)
Ø 3-5/16"
(84 mm)
Drain Hole
Ø 10-1/2"
(267 mm)
Drain Cutout
18-3/4"
(476 mm)
4"
(102 mm)
13"
(330 mm)
8"
(203 mm)
29"
(737 mm) 40-5/8"
(1072 mm) Max
16"
(406 mm)
15-3/4"
(400 mm)
16"
(406 mm)
63-5/16"
(1608 mm)
1-1/4"
(32 mm)
73-9/16"
(1868 mm)
8" (203 mm)
39-3/8"
(1000 mm)
63-1/4"
(1607 mm)
33"
(838 mm)
72"
(1829 mm)
73-1/4"
(1861 mm)
Product Diagram
63
″ (1600 mm) ROLL-IN SHOWER
Page 2 of 2
1016221-4-
J