Seiko 5R64 - Manual (Page 6)

English
11
English
10
Tips for more accurate time setting
• Take notice of the following points in order to set the time more accurately.
1. Before setting the time, wind the mainspring until the power reserve indicator
shows a full-wound state.
2. When using a watch after it has stopped, wait approximately 30 seconds after
the second hand starts moving, and then pull the crown out to the second
click.
3. Do not stop the second hand with the crown being at the second click position
for thirty minutes or longer. If the time the crown has been at the second click
position and the second hand has been stopped exceeds 30 minutes, push
the crown back in to its original position, and let the second hand move for
30 seconds or longer, then restart the time setting.
3. At the time when the second hand points to 12
o'clock (zero seconds), pull out the crown to the
second click to stop the second hand. Turn the
crown counterclockwise (the six o’clock
direction) to advance the time until the watch
shows the correct date.
4. While keeping the crown at the second click
position, slowly turn it counterclockwise (the
six o’clock direction) to advance the minute and
hour hand to the correct time taking AM and PM
into consideration.
5. Push the crown back in to the normal position in
accordance with a time signal. Immediately, the
second hand will start moving.
* The date changes once every 24 hours. When
setting the time, make sure that AM/PM is
properly set.
6
6