Smeg LAVATRICE LBS108F - Manual (Page 8)

8 - EN
Auxiliary functions
Auxiliary Function Selection Buttons
Select the required auxiliary functions before
starting the program.
C Some combinations cannot be selected
together. (Ex.: Pre-wash and Quick Wash.
Warning signal on the selected auxiliary function
will light up.
Auxiliary function selection
If an auxiliary function that should not be selected
together with a previously selected function is
chosen, the first selected function will be cancelled
and the last auxiliary function selection will remain
active.
(Ex.: If you want to select pre-wash first and then
quick wash, pre-wash will be cancelled and quick
wash will remain active.
Auxiliary function that is not compatible with the
program cannot be selected. (see, “Program
Selection Table”)
C Auxiliary function buttons may differ according
to the model of your machine.
• Prelavaggio (Prewash)
A pre-wash is only worthwhile for heavily soiled
laundry. Without pre-wash you save energy, water,
detergent and time.
C Pre-wash without detergent is recommended
for lace and curtains.
• Rapido (Quick Wash)
This function can be used for “Cottons” and
“Synthetics” programs. It decreases the washing
times for lightly soiled laundries and also the
number of rinsing steps.
• Risciacquo Aggiuntivo (Rinse Plus)
With this function, you can increase the number of
current rinsing steps. Thus, sensitive skins’ risk of
being affected by the remainder detergent on the
clothes will be decreased.
• Anti-Creasing
With this function, drum movement will be
lessened to prevent creasing and spinning speed
is limited. In addition, washing is carried out at a
higher water level.
C Whenever you select this auxiliary function,
load your machine with half of the maximum
laundry specified in the program table.
• No Heat
If you wish to wash your clothes in cold water, you
can use this program.
Time display
The display shows the time remaining for the
program to complete while a program is running.
Program duration may differ from the values in the
consumption table subject to the changes in the
water pressure, water hardness and temperature,
ambient temperature, type and amount of laundry,
auxiliary functions selected, and changes in the
supply voltage.
Time delay
With the “Time delay” function you can delay the
program start up to 24 hours. Time delay can be
set with steps of one hour for the first three hours
and with steps of three hours for the remainder (1,
2, 3, 6, 9, …24).
1. Pres “Time Delay” button to adjust the desired
time.
2. Press “Start/Pause/Cancel” button. The time
delay will start to count down.
C More laundry may be loaded during the time
delay period.
Changing the delay time
If you want to change the time during the
countdown:
1. Press “Start/Pause/Cancel” button.
2. Pres “Time Delay” button to adjust the desired
time delay.
3. Press “Start/Pause/Cancel” button.
Canceling the time delay
If you want to cancel the time delay countdown
and start the program:
1. Press “Start/Pause/Cancel” button.
2. Pres “Time Delay” button to decrease the time
delay.
3. Press “Start/Pause/Cancel” button to start the
program.
Starting the Program
1. Press “Start/Pause/Cancel” button to start the
program.
2. Program follow-up lamp showing the startup of
the program will light up.
Progress of program
Progress of a running program is shown through
the program follow-up indicator. At the beginning
of every program step, the relevant indicator lamp
will light up and light of the completed step will turn
off. The symbol that is lit up at the far right of the
series of symbols indicates the step that is being
carried out.
C If the machine is not spinning, the program
may be in rinse hold mode or the automatic
spin correction system has been activated
due to an excessive unbalanced distribution of
laundry in the machine.