Sharp VL-AH130U - Manual (Page 29)

V L - A H 1 3 0 U / p p . 0 1 8 - 0 2 0 ; 0 0 / 11 / 2 0 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
20
Basic Operations Camera Recording
Remaining Recording Time
Display
When the VIEWCAM is recording in Camera
mode, about 10 minutes before the tape
reaches the end, an on-screen indicator
displays the approximate remaining recording
time.
Remaining Battery Power
Display
When using the VIEWCAM with the battery
pack as the power source, you can turn on and
off the remaining battery power display by
pressing the DISPLAY button.
If the battery power becomes very low, a
warning indicator will appear. Replace the
battery pack.
To turn off the remaining recording time display,
press the DISPLAY button.
Notes:
• The remaining recording time displays only show
the approximate time left. Also, they vary slightly
depending on the length of tape used. (This
function’s design is based on the P6-120 tape
standard.)
• If you turn off the remaining recording time
display, it will reappear after a short interval to
indicate the new time remaining.
• The remaining recording time display appears
5 seconds after pressing the REC START/
STOP button to begin recording.
10 min.–8 min.
8 min.–6 min.
6 min.–4 min.
4 min.–2 min.
2 min.–1 min.
T A P E
T A P E
T A P E
T A P E
T A P E
Approx. remaining
recording time
On-screen
indicator
(Red)
(Green)
(Green)
0 min.
(The tape has
reached the end.)
1 min.–0 min.
Warning indicator
DISPLAY button
DISPLAY button
Remaining battery
power display
Notes:
• Use the remaining battery power display only as
an approximate indication.
• The battery power display may change to either
a higher or lower level if you set the Power
switch to OFF and then back to CAMERA or
VCR.
• In cold environments, the red remaining battery
power display may appear sooner. The battery
pack, however, can be used until the warning
indicator appears. Replace the battery pack at
this time.
• Battery consumption may vary depending on the
condition of use.
• Use of the zoom function when the warning
indicator is displayed may cause the VIEWCAM
to suddenly lose power.