Sherwood ST-670 - Manual (Page 47)

47
ENGLISH
OPERATING THE SLEEP TIMER
1
Press the SLEEP/TIMER button.
2
Press the CURSOR / button to select the desired sleep time.
• Then “SLP OFF” is displayed for several seconds.
• Each time the CURSOR or button is pressed, the
sleep time changes and disappear in several seconds as
follows:
OFF 10 20 30 60 90
• While operating the sleep timer, “ ” lights up.
• When the sleep time is selected, the display of the unit is
dimly lit.
• The sleep timer allows the unit to continue to operate for a specified period of time before automatically shutting off.
• While displaying the time, you cannot operate the sleep timer.
OPERATING THE TIMER
1
Press the SLEEP/TIMER button for more than 2 seconds to enter the timer setting mode.
2
Select the timer on mode and press the SLEEP/TIMER button.
• “TMR OFF”(or “TMR ON”)is displayed.
• To cancel the timer setting mode, press this button for
more than 2 seconds again.
• Then it enters the on time setting mode.
• Each time the ENTER button is pressed, the timer mode
changes as follows :
“TMR ON” : Timer on mode(“ ” lights up.)
“TMR OFF” : Timer off mode(“ ” goes off.)
• Once the timer is set to ON, it will operate at the preset time every day.
• While displaying the time, you cannot operate the timer.
Before setting the timer
• Make sure the clock has been set correctly. If not, when the SLEEP/TIMER button is pressed for more than 2 seconds,
“TIME ADJust” message flickers for several seconds.
In this case, first set the clock performing “SETTING THE CLOCK” procedure on page 46.