Skylink PT-434 - Manual (Page 3)

Press [L], when in the display will_
show I d
Activate the panic transmitter 5 seconds by
pressing the button on the transmitter. The red LED
light of the transmitter will be on when the button is
pressed. The display will return to clock mode once
the panic transmitter has been learned.
If the button of the panic transmitter is pressed, it
will trigger the Emergency Dialer and start
the preset phone numbers (refer to AD-433, AD-002
User’s Instruction for details).
In an emergency, you can
activate the re-
ceivers using the Panic
Transmitter. Move the slid-
ing cover and press the
panic button for one second.
This will activate the “learned”
Skylink receiver(s).
Note: Make sure you press
down on the transmitter for
one full second or the sys-
tem may not respond.
The Remote Control is
approved by the FCC and
it complies with Part 15
of the FCC Rules. Its
operation is subject to the
following two conditions
This device may not
cause harmful inter-
ference.
WARNING:
Changes or modification3
to this unit not expressly
approved by the party
ponsible of compliance
could void the user’s
authority to operate the
equipment.
2. This device must accept
any interference that
may cause undesired
operation.
Smarthome.com, Inc. (800) SMART-HOME
(949) 221-9200 http://smarthome.com