Sunbeam HE4900 User Manual

Page 11

The safety auto shut off detects any
abnormally high temperatures within the
heater and shuts it off to prevent
overheating. Should the safety auto shut
off activate and switch off the heater, it
will need to be reset.

1.To reset the heater, move the on/off switch

to the OFF position.

2.Unplug the heater and wait 5-10 minutes

for the unit to cool down.

3.After 5-10 minutes, plug the heater in

again and operate as usual.

Resetting the safety auto shut off

Care and cleaning

Ensure that the heater is switched off and
disconnected from the power outlet before
cleaning.

Carefully wipe the exterior of the heater with
a soft damp cloth and dry thoroughly with a
dry cloth.

Over time dust may accumulate on the front
vent of the heater, this can be removed by

wiping with a damp cloth, or carefully going
across the vent with a vacuum cleaner with
brush attachment.

Do not use harsh or abrasive cleaners to
clean your heater, as these will damage the
surface.

is a registered trademark of Sunbeam
Corporation Limited.

Euro Plus is a trademark of Sunbeam Corporation Limited.

Made in France. Due to minor changes in design or
otherwise, the product you buy may differ from the one
shown in this leaflet.

Backed by Sunbeam‘s 3 Year Replacement Guarantee and
National Service Network.

SUNBEAM CORPORATION LIMITED 2004.

(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
Sunbeam Corporation is a division of GUD Holdings Ltd.

For more information or advice on this or any other
Sunbeam appliance, visit www.sunbeam.com.au or
contact the Sunbeam Consumer Service Line.

Australia 1800 025 059
New Zealand (09) 912 0747.