Star Trac FITNESSTM S-UB UPRIGHT BIKE - Manual (Page 31)

STAR TRAC S SERIES BIKES O WNER ’ S M ANUAL 31
n
Vacuum the floor under and around the bike. Move the bike to another spot, if necessary, to vacuum thoroughly.
n
Inspect the display panel mounting screws for security, and retighten if necessary.
n
Inspect the display panel keypads for wear.
MONTHLY MAINTENANCE
Perform the following services each month, or as needed:
n
Check that the seat, pedals and shrouds are secure.
n
Tighten the pedals onto their respective pedal cranks using a 5/8-inch open end wrench.
M
ANAGER
/ M
AINTENANCE
M
ODE
After using your STAR TRAC S SERIES BIKE for a period of time, you may wish to change some of its settings.
MANAGER MODE
The Manager Settings allow you to query and modify the basic settings of your bike. To enter Manager Settings:
1. Press and hold the , and keys together.
2. A beep will sound and “MANAGER SETTINGS” will scroll once across the P ROFILE Window.
3. Release all keys. “SN” will display in the P ROFILE Window; the associated numeric value for the parameter will display
in the D ISTANCE Window.
NOTE:
The system will automatically exit Manager Settings if no key is pressed for 30 seconds.
The following keys are used to modify MANAGER SETTINGS:
Increase and Decrease Level Keys: Display the next (Increase) and previous (Decrease) parameters. Keys will
repeat if held.
Numeric Keypad: Facilitates entry of the desired value for the displayed parameter. These keys do not save the
new value – see OK Key below.
OK Key: Updates (saves) the value of the displayed parameter in Flash memory. “UPDATING” will scroll once
across the P ROFILE Window while the update is in process. When the update is complete, the P ROFILE Window will
show the new value for the parameter.
NOTE: To exit MANAGER SETTINGS without saving any values or settings, press the Q UICK S TART key.
NOTE: Unless otherwise specified, the Item (parameter) name is shown in the P ROFILE Window, and the value of the parameter is
shown in the D ISTANCE Window.
The items that you may display and change with the previous keys are:
Item
Lowest
Value
Highest
Value
Default
Value Meaning
SN 0 9999 N/A Serial Number. S Series Bike serial number (set by factory).
DSW 1.0 99.99 N/A Display Software. Display panel software version number (set by factory).
NOTE:
Software checksum value is displayed in C ALORIES Window.
OHR 0 9999 0 Operating Hours. Total operating hours.
DST 0 9999 0 Distance. Total distance ridden in miles or kilometers, based on current UNx
setting.
UNx UNE UNM UNE Units. UNE (English) = units of pounds, miles, feet, inches
UNM (Metric) = units of kilograms, kilometers, centimeters
NOTE: Current Value is shown in P ROFILE Window.
TIM 5 99 99 Time. Maximum time in minutes allowed for a program, excluding warm-up