Siemens Gigaset S1 - Manual (Page 7)

7
Preparing to use your phone
Gigaset S1 / englisch / A31008-S001-B002-2-6Z19 / start_guide_time.fm / 31.03.2003
The battery charging status is correctly displayed only after uninterrupted charging/
discharging. You should therefore avoid removing the batteries unnecessarily and
ending the charging process prematurely.
Manual registration
If automatic registration is interrupted or if you wish to use your S 1 handset at a
different Gigaset base (1000, 2000, 3000 or 4000 family), then you must register it
manually. You must initiate handset registration on the handset and on the base.
1. On the handset
Base 1 flashes in the display when the system PIN has been entered.
2. On the base
Please refer to the operating instructions for the base to find out how to initiate handset
registration on the base.
W
For the initial charge we recommend a continuous, uninterrupted
charging period of five hours, whatever charge status is indicated. After
a while the charge capacity of the batteries will decrease for technical
reasons.
i
◆ Once initial charging is complete, you can replace your handset in the
base after each call. Charging is controlled electronically. This ensures
that the batteries are charged in a way that maximises their life.
◆ The batteries heat up during charging. This is normal and not
dangerous.
Open the menu.
[______________________________________________] Settings Select the menu item and confirm.
[______________________________________________] Register H/Set
Select the menu item and confirm.
[______________________________________________] Base 1
Select base (1–4) and confirm, e.g. Base 1.
Enter the system PIN of the base (the default is 0000)
and confirm.
OK
OK
OK
OK