Shark GI468CN 12 User Manual
Page 12
11
TOLL FREE:
1-800-798-7398
Steam burst helps to
remove stubborn wrinkles
and can work both
horizontally and vertically.
Using the Burst of Steam Button
Electronic Auto-Off
Emptying the Iron
1
Make sure the water tank is at least 1/2
filled with water.
2
Select the desired fabric and tempera-
ture setting after reading the garment
label.
3
Place the iron on its heel, standing up
on a stable and protected surface so it
can heat up for approximately 2
minutes.
4
Press the steam burst button while
holding the iron horizontally or
vertically. Give an interval of 3
seconds of each burst. Overuse of
steam burst button may cause water
spitting or weak steam performance.
1
Always empty the water in the iron
after each use.
2
When you have finished ironing, turn
the variable steam control lever to “0”
and press the electronic temperature
control button until the power light is
lit.
3
Unplug the iron from the electrical
outlet.
4
Turn the iron upside down over the
sink with the tip pointing downward
and allow the water to flow from the
opening. Be cautious when emptying,
don’t touch the hot surfaces, water or
steam because injury may occur.
5
Place the iron upright and allow to
cool before storing.
The Shark
®
Rapido™ Electronic Iron is
equipped with an electronic auto-off
feature. The electronic auto-off
switches the iron off if it has been
unmoved in any position (sideways,
flat or upright) for approximately 7-9
minutes. The auto-off light will turn red
on the LED display panel when the iron
switches off. To turn the iron back on,
just gently rock the iron back and forth
several times until the “Power ON”
light is re-illuminated. Press the
Electronic Temperature Control to
reset the temperature to the desired
setting. The iron might have to warm
up for a minute if the auto-off feature
was activated for an extended time.
VERTICAL STEAM
5
The steam burst feature is especially
useful to remove wrinkles from
hanging clothes, delicate garments
and other fabrics. Hold the iron in a
vertical position several inches away
from the articles and press the steam
burst button to prime the pump.
CAUTION: Do not aim iron at yourself
or anyone else while using the steam
burst feature. Be careful, burns or
serious injury may occur.
CAUTION: Never iron or steam
clothes while they are being worn.
If the tank runs dry, always make sure
you unplug the iron from the outlet
before you refill.
3
2
4
5
7-9
MINUTES
4
2