Samson MDR 16 - Manual (Page 2)

578mm
95mm
413mm
MDR 16
PRODUCT SPECIFICATION SHEET
SERIES DESCRIPTION CATEGORY
MDR MIXER MIXERS
FEATURES
(continued)
> 2 TK TO MIX control allows you to mix in a CD, DAT,
Cassette, Computer Sound Card or Mini Disk.
> The mono inputs feature a three-band channel equalizer
with 15dB of cut or boost at 80Hz, variable mid-range
from 100 Hz to 5 KHz with 15dB of cut or boost and 15dB
of cut or boost at 12KHz, plus a Low Cut filter at 80Hz.
> Two Auxiliary Sends, with Pre-Post switching on Aux 1, can
be used to route signals to external effects, or to create a
separate mix for on-stage monitors, or studio headphones.
> Twelve-segment LED Meter, with VU ballistics, displays the
main MIX output, plus SOLO, PFL, Phantom and Power
LED indicators.
> High quality, low noise, discrete microphone pre-amplifiers,
with 48-Volt phantom power, provide Maximum Dynamic
Range and transparent audio.
> Advanced circuit design using discrete components and
high quality, low noise op-amps carefully selected at each
stage of the signal path.
> Quality build and rugged construction ensure reliable
performance from venue to venue and session to session.
> Three-year extended warranty.
MDR 16 SPECIFICATIONS
Frequency Response (Trim @ Min, unity gain +0 / -1 dB)
Mic to Main ........................ 10 Hz - 30 kHz
Line to Main ....................... 10 Hz - 30 kHz
Aux Return to Main ............. 10 Hz - 30 kHz
Line to Aux Send ................ 10 Hz - 32 kHz
T.H.D. (Trim @ Min, +4dBu output, unity gain, 1 kHz w/30 kHz LPF)
Mic/Line to Main (Mono Ch) . 0.02%
Line to Main (Stereo Ch) ...... 0.02%
Line to Aux Send ................ 0.02%
Equivalent Input Noise ("A" filter on, input shorted)
Mic .................................... -128 dB
Line ................................... -103 dB
Maximum Voltage Gain
Mic to Main ........................ 72 dB
Line to Main (Mono Ch) ....... 56 dB
Line/Tape to Main (Stereo Ch) 20 dB
Aux Return to Main ............. 20 dB
Mic to Aux Send ................. 74 dB
Line to Aux Send (Stereo Ch) . 41 dB
Residual Noise (30 kHz LPF, all control Min)
Main .................................. -85 dBu
Aux Send ........................... -82 dBu
Crosstalk (@ 1 kHz w/ 30 kHz LPF)
Ch vs. Ch ........................... -75 dB
Input vs. Output ................. -86 dB
Peak LED Sensitivity (before clipping) .... 5 dB
CLIP Indicators ................................ Turn on: THD> 0.1%
Headphone output (600 ohm load) ..... 100 mW
Maximum Input Level (1 kHz, Ch. & Mix fader set to zero)
Mic Input (Mono Ch) ........... +11 dBu
Line Input (Mono Ch) .......... +27 dBu
Input Channel Equalizer (± 2dB)
High (shelving) ................... 12 kHz ±15 dB
Mid (peaking) ..................... Variable 100Hz - 5 kHz ± 15 dB
Low (shelving) .................... 80 Hz ±15 dB
Meters ............................................ 12 POINT LED METERS (-21,
-18, -16, -12, -8, -6, -3, 0,
+3, +6, +9, +20) PEAK
Internal DSP Effects ......................... 24 BIT -8 presets: 1 - Large
Hall; 2 - Medium Hall, 3- Large
Room; 4 - Vocal Room 1;
5 - Vocal Room 2; 6 - Chorus +
Reverb; 7 - Chorus + Delay;
8 - Stairwel
Phantom Power ................................ +48V
Power Requirement .......................... 110V-240V, 50/60Hz
Power Consumption .......................... 50W
Dimensions (W x D x H) ................... 22.75” x 16.25” x 3.75”
(578mm x 413mm x 95mm)
Weight ............................................ 17.5 lbs. (8 kg )
ARCHITECT’S & ENGINEER’S SPECIFICATIONS
The Samson MDR16 shall be a 16 input, 4 bus stereo output
mixer. It shall have 8 mic channels with trim control, HF
Level control, High pass switch, MF level and frequency
sweep, LF Level control, 2 aux sends (one pre / post
switchable), pan control, solo button, bus 1-2 switch, bus 3-4
switch and a 60mm fader. It shall have 8 mic/line channels
with High frequency control, low frequency control, 1 aux
control with aux 1/2 switch, pan control,solo button, bus 1-2
switch, bus 3-4 switch and 60mm fader. 60mm bus 1, 2, 3,
and 4 and left and right output faders will also be available.
A control room and headphone output with level control shall
also be provided. 24 bit, DSP effects shall also be provided
with 8 presets. A nine band graphic equalizer is also available
in the master section with the ability to equalize the main mix
or the aux 1 mix. The MDR16 uses an external power supply.