Smeg STA4645U - Manual (Page 68)

14
Rev 0.0
INSTALLATION INSTRUCTIONS EN
5.1.2 Levelling the appliance
Level the appliance using the relative adjustable feet (e.g.: ref. A fi g. 5-02);
use an open-ended wrench to rotate the feet until the dishwasher is perfectly
level.
Some models are fi tted with just one rear foot which can be adjusted with
a screw located at the bottom front of the appliance (ref. A fi g. 5-03); use a
suitable Phillips screwdriver to turn the screw until the dishwasher is perfectly
level.
Use a spirit level to check the appliance is perfectly level (ref. B fi g. 5-02).
Leveling is vital for assuring correct dishwasher operation.
Make sure to leave a gap of at least 3 mm (7/64”) between the top of the dish-
washer and the worktop (ref. C fi g. 5-02).
Fig. 5-02