Samson Resolv 50a - Manual (Page 13)

11
ENGLISH
10 Inch Long Throw Transducer 120 Watt Amplifier
+4 INPUT
-10 INPUT
DESIGNED AND ENGINEERED IN THE UNITED STAT THE UNITED ST THE UNITED ST ES BY SAMSON
www.samsontech.com
CAUTION
S/N
RISK OF ELECTRIC SHOCK DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W POWER RATING
RESOLV MONIT RESOL RESOL ORS CAN A EXTREMELY HIGH SOUND EXTREMEL EXTREMEL
PRESSURE LEVELS. USE CA PRESSURE LEVELS. PRESSURE LEVELS.
OR HEARING DAMA S/N GE MA
10 -27
-21 -15 -9
0 5
100 1K 10K 30K FREQUENCY (Hz) CROSSOVER
dBr
RISK OF ELECTRIC SHOCK DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W POWER RATING
10 -27
-21 -15 -9
0 5
100 1K 10K 30K FREQUENCY (Hz) CROSSOVER
dBr
FROM MIXER
R
L
Connecting to the Resolv120a Subwoofer
RESOLV 50a with Mono Sub
Adding a subwoofer (and extended low frequency response) to your RESOLV 50a system is easy using the RESOLV 50a’s
LINE LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with a mixer and a pair of RESOLV 50a satellite
speakers. For a detailed wiring diagram, see the section “RESOLV 50a Connections” on page 12. Follow the steps in the
diagram below to set up your system:
• Lower your mixer’s master outputs to all the way off.
•
Connect the mixer’s Left output to the RESOLV 120’s LEFT PREAMP LEVEL INPUT and the mixer’s Right output to
the RESOLV 120’s RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120’s LEFT PREAMP LEVEL OUTPUT to
the input of the left RESOLV 50a, and the RESOLV 120’s RIGHT PREAMP LEVEL OUTPUT to the input of the right
RESOLV 50a.
• Run an audio signal (like some music from a CD) through your mixer and raise the level to a comfortable
listening level.
• Now adjust the SWEEP control to the desired frequency. A good place to start is about 70 Hz. You can also use
your ears by adjusting the SWEEP control to the frequency that sounds good to you.