Spectra Logic 2K User Manual
Page 17

Chapter 2. Installing the Library
17
5.
Determine the correct specifications for the SCSI terminator as described in SCSI
Terminator Requirements on page 81. Attach a SCSI terminator to the free SCSI
connector on the library, as shown in Figure 2-5.
Caution:
The SCSI bus must be terminated at both ends or unexpected
errors may result. Make sure that the SCSI adapter in the host
computer has the appropriate termination enabled.
6.
To attach additional devices to the SCSI bus, continue with Attaching More than
One SCSI Device and complete any further procedures as necessary.
The SCSI card BIOS should display the following information:
SCSI ID: 1 Sony SDX-300C
or
Sony SDX-500C
or
Sony SDX-700C
SCSI ID: 2 Sony SDX-300C
or
Sony SDX-500C
or
Sony SDX-700C
(if Drive 2 is installed)
SCSI ID: 3 Spectra 215
Terminator
SCSI cable
Library
Computer
SCSI cable
Figure 2-5 Connect the library to the host computer with the SCSI cable. Connect a SCSI terminator
to the library (as necessary).