Sharp CDPC3500 User Manual
Page 13
SETTING THE CLOCK
POWER
ON/
STAND-BY
CLOCK
MEMORY/SET
TUNING/
TIME
( )
In this example, the clock is set for the 12-hour (AM 12:00) sys-
tem.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.
4
Press the TUNING/TIME (
X
or
W
) button to select the time
display mode.
"AM 12:00"
→
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00"
→
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"0:00"
→
The 24-hour display will appear.
(0:00 - 23:59)
●
Note that this can only be set when the unit is first installed
or it has been reset (see page 21).
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME (
X
or
W
) button to adjust the hour.
●
Press the TUNING/TIME (
X
or
W
) button once to advance
the time by 1 hour. Hold it down to advance continuously.
●
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME (
X
o r
W
) button to adjust the
minutes.
●
Press the TUNING/TIME (
X
or
W
) button once to advance
the time by 1 minute. Hold it down to change the time in 5
minute intervals.
●
The hour setting will not advance even if minutes advance from
"59" to "00".
9
Press the MEMORY/SET button.
●
The clock starts operating from "0" second.
(Seconds are not displayed.)
And then the clock display will disappear after a few seconds.
To see the time display:
Press the CLOCK button.
●
The time display will appear for about 5 seconds.
Note:
●
The clock display will flash on and off at the push of the CLOCK
button when the AC power supply is restored after a power
failure occurs or after the AC power cord is disconnected.
If this happens, follow the procedure below to change the clock
time.
To change the clock time:
①
Press the CLOCK button.
②
Within 5 seconds, press the MEMORY/SET button.
③
Perform steps 6 - 9 above.
To change the time display mode:
①
Perform steps 1 - 2 in the section "RESETTING THE
MICROCOMPUTER", on page 21.
②
Perform steps 1 - 9 above.
(Main unit operation)
AM 12:00
AM 0:00
0:00
2
3
4
7
6
5
8
9
CD-PC3500(SEC) TINSE0281AWZZ
12