beautypg.com

Technical specifications – Shark GI460 User Manual

Page 3

background image

GETTING TO KNOW YOUR GARMENT STEAMER/IRON

TROUBLESHOOTING

PROBLEM

POSSIBLE REASONS & SOLUTIONS

Garment Steamer/Iron
does not heat

Pilot light
goes On and Off

Some odor or small
particles come out of
steam vents of new
iron

Garment Steamer/Iron
does not steam

Water droplets coming
from steam vents

• Make sure that the plug is securely in the socket.
• Temperature setting too low.

Turn to higher setting.

• This is normal.

The light goes On and Off as the thermostat is
switching the heating element On and Off to
maintain the selected temperature.

• This is normal.

Follow instructions for first use and allow iron to steam
through 2-3 fillings & press the steam trigger
occasionally to eliminate small white particles.

• Water tank may be empty or water level is very low.

Add water.

• Make sure that the temperature control dial is correctly

set. For maximum steam, (setting ‘Max’ on steam
control), temperature control dial should be set on ‘•••’.

• Make sure the iron has reached the selected

temperature by confirming that the pilot light has gone
"Off". For more steam, turn temperature dial to
higher setting, e.g. ‘•••’.

• If temperature setting is correct and there is no steam,

gently tap the soleplate on the ironing board a few
times. Move the temperature control dial from ‘MIN’ to
‘Max’ a few times.

• Iron may not be hot enough. Set temperature control

dial to the ‘Max’ position. Always allow iron sufficient
time to heat up (pilot light goes off).

• Overuse of steam trigger. Allow more time between

each burst.

• Iron may have been overfilled. Turn iron off,empty

water and follow instructions for filling.

• Steam performance may be low if iron requires

seasoning. To season, use regular tap water for 1or 2
tanks until steam performance improves.

1. Temperature Control Dial
2. Red Pilot Light
3. Steam Trigger
4. Water Inlet Cover
5. Red Lint Brush
6. Bristle Garment Brush
7. Locking Tab
8. Swivel Handle
9. Water Measuring Beaker
10. Dual Voltage Selector

(not shown)

Technical Specifications

Voltage:

115/120 V., 60Hz.
230/240 V., 50 Hz.

Power:

800 Watts/870 Watts

2

9