Soundstream Technologies 300SX - Manual (Page 9)

l
ACCESSORY
Soundstream’s new feature can be added to the
amplifier. This feature allows wireless RF remote control
level adjustment of the amplifier, while the low pass filler on the amplifier’s
internal crossover is engaged.
NOTE: The accessory is intended be used only the
amplifier is driving When the
accessory is added to a
configures the into Bridged Mono mode. (The Coherent
Mono/Bridged Mono switch is bypassed.) Therefore, when
follow the Mono and instructions.
Installing involves removing the bottom plate of the amplifier,
adding the circuit board, and flipping a switch. The switch is
labeled on the amplifier’s main circuit board. DO NOT set the
switch to the ‘IN’
unlessthe module has been added. DO
NOT move the switch while the amplifier is ‘ON’. Doing so
damage your speakers. (Please refer to the owner’s installation
manual for more details.)
TROUBLESHOOTING
P R O B L E M
I
C A U S E
No sound and are not lit
l no power or ground at amp
l
no remote signal
l blown fuse near battery
No sound and are lit, and
is not installed
. switch is engaged
Fault LED is lit. Amp has power, but
l
amp power supply fuse is blown or
the Power LED is not lit missing
Repeatedly blown amp fuse, . check speaker configuration, amp
activation of Smart Power be in “High Power” mode, put
C i r c u i t amp into “High Current” mode if
speaker load is less than 2 ohms
(see
“Setting High Power/High
current
l speaker or leads be shorted
. verify adequate ventilation
l
High Power 50x2 100x2 150x2
1) (300 1)
High Current 25 x2 100x2 150x2
watts (50 1) 1) (300x 1)
THD %
Signal to Noise
Frequency Response
Stereo Separation
Damping
Input Sensitivity
Input Impedance ohms
Crossover Specifications
High Pass: 12 factory at 150 Hz
Low Pass: 12 factory set at 75 Hz
Dimensions (W x D x
8.625” 9.8” 2.25”
SERVICE
Your Soundstream REFERENCE amplifier is protected by a limited warranty.
Please read the enclosed warranty card.
16