Sanyo ECD-T1550 - Manual (Page 9)

SET THE CLOCK
Press the DSP button (15), the clock is
shown on the LCD display. Then hold down
the button until the clock flashes. Then
press the MANU/SKIP button (17) to
change hours or MANU/SKIP button (16)
to change minutes.
MUTE
Press MUT button (2) to mute down the
sound instantly. If any button (except
button (4)) is pressed in the mute state, the
mute mode is released.
EQUALIZATION
Press EQ button (24) to turn on equalization
function and to select desired audio mode.
There are five kinds of mode as below:
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (8).
AUXILIARY INPUT
The unit can be connected to a portable
audio player through the AUX IN jack (7).
Note : The face plate will not close when
something is plugged in the AUX in jack.
REMOTE SENSOR
Point the remote control handset to the
remote sensor IR (23). Press the function
keys on the handset to control the system.
RESET FUNCTION
RESET button (12) can be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when
all wiring is completed.
- All the function buttons do not
operate.
- Error symbol on the display.
9
OPERATION
SWITCHING ON/OFF THE UNIT
When the hidden panel turns up (in State
2), switch the unit on by pressing any
button (except button (4)). When system
is on, press (9) to turn the unit off.
SOUND ADJUSTMENT
Press SEL button (10) to select the
desired adjustment mode.
The adjustment mode will change in
the following order:
By pressing VOLUME + button (11) or
VOLUME- button (27), it is possible to
adjust the desired sound quality.
BEEP ADJUSTMENT
Press SEL button (10) and hold for more
than 2 seconds until “BEEP“ appears on
display.
Press VOLUME+ button (11) or
VOLUME- button (27) as follows:
BEEP 2ND BEEP ALL BEEP OFF
- BEEP 2ND mode:
The beep is only generated when all
allowed double function button is
pressed long (several seconds). e.g.
When preset button is pressed.
When BND/LOU button (13) is
pressed.
When AMS button (18) is pressed.
- BEEP ALL mode:
The beep is generated when every
button is pressed.
- BEEP OFF mode:
The beep is disabled.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
FLAT CLASSICS POP M ROCK M DSP OFF