Sunbeam HEALTH AT HOME 7623 - Manual (Page 6)

Press the exhaust valve to remove. the from the cuff.
When initial pressurization was insufficient, the symbol
n
appear.
Repressurize the cuff to a value 30 to greater than the previous time.
If an error message is displayed, or you get a reading that you do not believe is
accurate, wait 10 minutes before trying again.
Memory Operation ,
1. When a valid measurement is made, the reading data (systolic, diastolic and
pulse rate) will be stored in the MEMORY as soon as the unit is turned off.
2. The reading in MEMORY can be viewed at any time (except when another ,
measurement is in progress) by pressing the MEMORY button. An appears
in the lower left corner of the display when you are viewing the data in MEMORY.
3. After another is performed, of this current
measurement will appear on the display. When the MEMORY button is pressed,
the previous reading will appear once on the display (along with the
symbol). Then the display will revert to the current reading.
4. When the unit is shut off (either by manually pressing the ON/OFF button or
when the Auto-off feature operates) the last valid reading taken will be stored
in MEMORY, overwriting the previous data.
Page 5