Stanton S.300 - Manual (Page 4)

4
1. EJECT- Opens the CD door.
2. STOP- Stops the CD.
3. SKIP- Skips through the tracks on the CD, forward or back.
4. - Scans forward or back through the current track. This unit
features 4 scan speeds. Keep the or button pressed for a
few seconds to change the scan speed.
5. PLAY/PAUSE- Plays or pauses the CD. Autocue function sets the
cue point automatically when this button is used.
6. CUE- Used to recall and preview the cue point.
7. TIME- LCD display reads the time remaining or time elapsed,
according to this button.
8. PITCH
PITCH BUTTON- Turns pitch fader ON and OFF.
PITCH BEND- Maximum pitch on this unit is 16%. If the pitch fader
is already physically set to 16%, this function will not work.
Pressing the PITCH and PITCHBEND-(minus) buttons
simultaneously changes the pitch fader range between +/- 4,
8, and 16%.
9. +10- This button allows you to skip ahead by 10 tracks. Example: if
you are at Track #1, pressing this button will skip you to Track #11,
press the button again, it will skip to Track #21. If there are not that
many tracks, it will go back to Track #1.
10. SGL/CTN- Switches between Single or Continuous play modes.
11. PITCH FADER- Used to speed up or slow down current track.
CONTROLS OVERVIEW CONTROL PANEL
1
2
3
4
6 7 8
10
11
5 9