Sub-Zero 315W - Manual (Page 7)

7
S U B - Z E R O M O D E L 3 1 5 W I N S T A L L A T I O N
K I C K P L AT E A I R F L O W
The wine cooler uses a fan to take in room air
through vents in the left side of the kickplate,
and discharges warm air through vents in the
right side. These vents must be kept clear of
obstructions or decorative panels. Blocking or
obstructing the kickplate will restrict air flow
and cause a decrease in performance and
efficiency. Refer to the illustration below.
IMPORTANT NOTE: The minimum air
temperature the wine cooler will operate in is
50˚F (10˚C), and the maximum is 100˚F (38˚C).
M OV I N G T H E U N I T
IMPORTANT NOTE: When you move the unit
using a hand truck or dolly, position the dolly
on the side of the unit and secure the door so
it does not open while transporting.
IMPORTANT NOTE: When moving and
installing the Model 315W/S, be sure to protect
all stainless steel surfaces from scratches.
Once the unit is in place, remove any tape or
other packaging material from the inside.
Check that all wine shelves fully extend.
E L E C T R I C A L R E Q U I R E M E N T S
A 115 V AC, 60 Hz, 15 amp circuit breaker and
electrical supply are required. A separate
circuit is required for each unit.
The Model 315W is equipped with a power
supply cord with a 3-prong grounding plug,
which must be plugged into a mating 3-prong
grounding-type wall receptacle. Refer to the
illustration below. Follow the National
Electrical Code and local codes and ordinances
when installing the receptacle. For location of
the electrical supply, refer to the Rough
Opening Dimensions illustration on page 6.
IMPORTANT NOTE: A ground fault circuit
interrupter (GFCI) is not recommended and
may cause interruption of operation.
GROUND
NEUTRAL
LINE POWER
(VOLTAGE)
C O L D
E R
ROOM AIR IN
WARM AIR OUT
Grounded electrical outlet Kickplate airflow
Do not use an extension cord or two-
prong adapter. Electrical ground is
required on this appliance. Do not remove
the power supply cord ground prong.
Any finished flooring should be protected
with appropriate material to avoid any
damage from moving the unit.