Shindaiwa 89301 - Manual (Page 6)

X unit
Outer Tube
Handle
Barrier Bar
4 Socket-head
capscrews
Handle position label
The handle is attached at the factory and
positioned vertically.
Loosen socket headed capscrew(s) at 1.
the base of handle and rotate the han-
dle 90 degrees.
Handle and barrier bar X unit
NOTE:
Keep handle forward of handle posi-
tioning label!
Position the handle forward of the 2.
Handle Positioning Label at the best
position for operator comfort (usually
about 254 mm (10 in.) ahead of throttle
housing).
Tighten the socket headed capscrew 3.
securely.
Rotate and position handle in best location for operator comfort
6
Assembly
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Engine and shaft assembly
Ŷ
Cutting attachment shield
Ŷ
Cutting attachment
Ŷ
Kit containing cutting attachment
Ŷ
shield, mounting bracket and hardware,
this owner’s/operator’s manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a spark
plug/screwdriver combination wrench,
and a scraper.
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.