Smeg 142468 - Manual (Page 9)

142468
Required tools; socket spanner nr. 8,
screwdriver, torx 25.
Caution! After unscrewing of before fi xing hinges,
hold the door to prevent it from falling and
damaging.
1. Remove upper hinge cover (save it for eventual
later use), remove also the cover on the opposite
side of the upper hinge cover (on the opposite
side you will insert the attached cover during the
assembly), and remove the cover on the opposite
side of the upper part of the door.
2. Unscrew upper hinge screws and remove the
upper door from the middle hinge.
3. On the bottom side of the upper door unscrew the
swing stopper screws and remove the stopper
(A). Keep this for eventual use later on. Fix the
attached stopper with its bearing on the opposite
side of the door.
4. Unscrew the forced door closure system (B)
and fi x it to the opposite side of the door (certain
models only).
5. Unscrew middle hinge screws, remove the door
from bottom hinge.
6. Unscrew leg holder fi xing screws.
7. Tilt the appliance backward (max. 35°) to lean
to the rear side of the cabinet. Unscrew the
leg support screws (C) - left and right, and
remove the leg support cover (D) and place it to
the opposite side. Unscrew and remove, then
reciprocally replace the position of end switch (E)
and decorative peg (F) (for models with forced
door closing system). Unscrew three screws
fi xing the bottom hinge (save the hinge for later
use), and fi x the attached bottom hinge on the
opposite side.
8. Repeat the procedure 3 and 4 on the bottom
door. In case there is no bottom door limit peg,
transfer the bearing (G) and washer to the
opposite side of the door.
9
Reverse door swing