SVAT Electronics CVDVR200 - Manual (Page 11)

MENU SETTINGS
4. When the new password is accepted, the system will flash the following
screen message: Password Change !!!
5. The message will flash 5 times.
6. Then, it will be back to the SUB MENU
If the password is not accepted, you will receive a message to inform you:
Password Incorrect , then return to the SUB MENU . You may try again by
repeating the same steps.
Time Set
1. Below is a screen shot of the Time Menu screen, you can change
time/date/hour/year by using TIME SET menu.
(This represents year/month/day and hour/minute/second)
2. Use the and button on the front panel to move the ? cursor below the
number back and forth. Then, use the SELECT button to change the numeric
values of date & time.
3. When you press the MENU button, your setting is memorized by the system.
Full Screen by Sensor
When FULL SCREEN BY SENSOR is selected, you can choose [ON] or OFF] this
function. If you choose [ON], when sensor device is attached to the DVR
and receive motion signal, the screen will display a single full screen of this
area.
Sequent View Time
When SEQUENT VIEW TIME is selected, you can select sequent view time by
02, 03, 04, 05, 06, 07, 08, 09, 10 seconds or [OFF] (= turn off the function).
Hard Drive Setup
(When you select HARD DRIVE SETUP , the screen will display HARD DRIVE
SETUP page.)
TIME
2005/01/01 01:01:00
PRESS (< , >) THEN (SELECT)
PRESS (MENU) TO EXIT
HARD DRIVE SET UP
> OVERWRITE ENABLED YES
MASTER HDD SIZE (Depends on HDD you choose)
MASTER HDD USED MB %
MASTER HDD FORMAT (for format master HDD)
SLAVE HDD SIZE (Depends on HDD you choose)
SLAVE HDD USED MB %
SLAVE HDD FORMAT (for format master HDD)
PRESS (< , >) THEN (SELECT)
PRESS (MENU) TO EXIT