Sharp AR-M236 - Manual (Page 36)

34
INTERRUPTING A COPY RUN
A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.
1 Press the [INTERRUPT] key ( ) to
interrupt the copy run.
The [INTERRUPT] key
(
) blinks until the
machine is ready for the
interrupt job, after which
it lights steadily.
If you decide to cancel the
interrupt job while selecting
settings, press the
[INTERRUPT] key (
).
2 Remove the previous original(s) and
place the original(s) of the interrupt
copy job. (p.22, p.23)
3 Select the number of copies and any
other desired copy settings, and then
press the [START] key (
).
The interrupt copies will
be offset from the
previous copies. (Offset
function, p.35)
4 When the copy job is finished, press
the [INTERRUPT] key (
) and remove
the original(s).
5 Replace the previous original(s) and
press the [START] key (
) to resume
copying.
Replace only the originals that have not yet been
scanned.
Automatic two-sided copying, sort/group copying, staple sort, cover copy, pamphlet copy, mixed feeding, job
build, job programs, or multi shot copying cannot be used for interrupt copying. Note
• If audit mode is enabled, a message will
appear prompting you to enter your
account number. Enter your account
number with the numeric keys. The copies
that you make will be added to your
account’s count.
• If an original is being scanned when the
[INTERRUPT] key ( ) is pressed, the
interrupt job will begin after the original is
scanned. If a copy is being printed, the
interrupt job will begin after the copy is
printed.
Note
ACC.#-C