Sirius Satellite Radio SIR-SL1 User Manual

Page 13

Streamer GT SIR-SL1 User Guide

Vehicle Installation: Running the Antenna Cable

1. Turn the SIR-SL1 receiver power OFF and

remove it from the mount; unplug the Car Power
Adapter from the cigarette lighter; unplug the
antenna from the Receiver.

2. Route the cable from the antenna to the vehicle’s

interior by tucking it underneath the rubber
molding around rear window, as shown.

3. Route the cable from the lowest point of the rear

window into the trunk. Take advantage of any
existing cable channels or wiring conduits.

• For SUVs, minivans & 5-door vehicles, bring the

cable into the vehicle under the rubber molding for
the tailgate, and continue under the interior trim.

4. From the trunk, route the cable around the

passenger compartment and to the back of the
cradle.

• Do not pull the wire across sharp edges that could

damage it.

• Keep the wire away from areas where it could

become tangled in driver’s and passenger’s feet.

5. Plug the antenna back into the SIR-SL1 Receiver’s

ANTENNA jack.

6. Plug the car power adapter into the cigarette lighter.

IT IS RECOMMENDED THAT YOU UNPLUG THE
CAR POWER ADAPTER AFTER THE VEHICLE’S
IGNITION IS TURNED OFF.