Summit SM900WH - Manual (Page 6)

5
Installation
1. Make sure that all the packing materials are removed from the inside of the
door.
2. WARNING: Check the oven for any damage, such as misaligned or bent
door, damaged door seals and sealing surface, broken or loose door hinges
and latches, and dents inside the cavity or on the door. If there is any
damage, do not operate the oven and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable surface to hold its
weight and the heaviest food likely to be cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated,
or near combustible materials.
5. For correct operation, the oven must have sufficient airflow. Allow 7.9” of
space above the oven, 3.9” at back and 2” at both sides. Do not cover or
block any openings on the appliance. Do not remove feet.
6. Do not operate the oven without glass tray, roller support, and shaft in their
proper positions.
7. Make sure that the power supply cord is undamaged and does not run under
the oven or over any hot or sharp surface.
8. The socket must be readily accessible so that it can be easily unplugged in an
emergency.
9. Do not use the oven outdoors.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for the
electric current.
WARNING: Improper use of the grounding plug can result in a risk of electric
shock.
Electrical Requirements
The oven must be plugged into at least 15 amp, 120 volts, 60 Hz grounded
outlet. It is recommended that a separate circuit serving only the oven be
provided. The oven is equipped with a 3-prong grounding plug. It must be
plugged into a wall receptacle that is properly installed and grounded.
English English