Sony SRX-T110 - Manual (Page 17)

17
Connecting a Computer for Controlling the Projector
Cha
p
te
r 2
P
repa
ra
ti
ons
Installation of the SRX Controller is completed.
To restart the SRX Controller immediately after
installation has been completed, click to check
“Launch SRX Controller for SRX-T series”, then click
“Finish”.
The icon is displayed in the desktop window.
Connecting a Computer
for Controlling the
Projector
Connect a computer for controlling the projector to the
projector via the ETHERNET connector or the RS232C
connector.
Connecting the Computer via the
Ethernet
Connect the computer to the projector using the supplied
ethernet cable (cross cable).
Set the TCP/IP protocol of the connected computer to
DHCP.
Note
INTER LOCK ETHERNET RS232C
AUX DVI-D
ETHERNET connector
Ethernet cable (cross cable)
(supplied)
Computer
Ethernet connector