Sharp TINSEB520MRK0 - Manual (Page 11)

11
Please check the following before calling for service. It may save you time and expense.
prOBleM pOssiBle Cause sOlutiOn
Part or all of Warming 1
Drawer does not operate.
Power cord of Warming Drawer is not •
completely connected to the electrical
outlet.
Power outage.
•
Fuse blown/circuit breaker tripped. •
Make sure the power cord is tightly connected •
to the outlet.
Check house lights to be sure. Call your local
•
electric company for service.
Replace the fuse or reset the circuit breaker.
•
Food in Warming Drawer is 2
not heated.
No power to the appliance. •
Drawer controls improperly set. •
See SOLUTION for PROBLEM 1. •
Check if the controls have been properly •
set.
Warming Drawer light does 3
not work.
Light bulb is loose or burned out. • Call for service. •
Touch controls will not 4
operate.
Power cord of Warming Drawer is not •
completely connected to the electrical
outlet.
Power outage.
•
Fuse blown/circuit breaker tripped. •
Make sure the power cord is tightly connected •
to the outlet.
Check house lights to be sure. Call your local
•
electric company for service.
Replace the fuse or reset the circuit breaker.
•
Power light off. 5 Power failure. • If the Warming Drawer was in use, you must •
reset the heating function.
Drawer does not slide 6
smoothly or drags.
Ball bearings are out of alignment. •
Drawer over-loaded or load unbalanced. •
Drawer not replaced properly after removal. •
Fully extend the drawer and push it all the way •
in. See the Care and Cleaning section.
Reduce weight to less than 50 pounds.
•
Redistribute drawer contents.
Remove drawer and replace again.
•
Excessive condensation. 7 Liquid in Warming Drawer. •
Uncovered foods. •
Temperature setting too high. •
Incorrect Humidity setting. •
Remove liquid. •
Cover food with lid or aluminum foil. • DO
NOT use aluminum foil to line any part of
the Warming Drawer.
Reduce temperature setting.
•
Set the Variable Humidity Control to the open •
vent setting to allow venting.
No heat in the proof setting. 8 Room temperature may prevent the thermostat •
from tripping on.
Press TEMP to select LOW and then select •
PROOF.
Food dries out. 9 Moisture escaping. • Cover food with lid or aluminum foil. • DO
NOT use aluminum foil to line any part of
the Warming Drawer.
Set the Variable Humidity Control to the
•
closed vent settings to prevent venting.
BeFOre yOu Call FOr serviCe