Woodstock NAILER/STAPLER KIT W1775 - Manual (Page 10)

Model W1775 Nailer/Stapler Kit
-8-
OPERATIONS
Loading
When replacing brad nails in your Model
W1775, follow these guidelines:
Gauge: 18
Brad Length:
5 ⁄
8
"-2"
Staple Length: 5 ⁄
8
"-1 5 ⁄
8
" (crown 1 ⁄
4
")
Capacity: 100
To load your nailer/stapler, do these
steps:
1. DISCONNECT NAILER/STAPLER FROM
THE AIR SUPPLY!
2. Grip the nailer/stapler firmly,
unlatch the catch lever ( Figure 3),
and pull the magazine pusher back
completely.
3. Insert a strip of brads or staples,
pointed-end down, into the magazine
as shown in
Figure 4.
If you have not read the safety
instructions in this manual, do not
operate the nailer/stapler.
Before you operate your nailer/stapler,
place two to three drops of the included
oil into the quick connect fitting where
the nailer/stapler connects to the air
supply, unless using a lubricator unit.
To operate your nailer/stapler, do these
steps:
1. Connect the air supply to the quick
connect fitting.
Operating
4. Slide the staples or brads all the way
down to the nose of the nailer/sta-
pler.
5. Push the magazine toward the nose of
the nailer/stapler until the catch lever
locks.
6. Reload the nailer/stapler when the
magazine sight window ( Figure 4)
shows the nail or staple level is low.
The sight window shows up to approxi-
mately 50 nails or staples loaded.
Figure 4. Loading nails into magazine.
Figure 3. Catch lever engaged and
magazine pusher retracted.
Pusher
Sight Window
Magazine