beautypg.com

Sony VGC-RBxx Series Hard Disk Drive (Replacement Instructions) User Manual

Important! please read before you start

background image

P/N 994630000

Rev. E

1/2

VGC-RBxx Series Hard Disk Drive

Replacement Instructions





















































These easy instructions are intended to guide you through the replacement process.

ü

To avoid electric shock please make sure product is turned off and disconnected from the power source.
Remove jewelry before you begin work to avoid scratching the surface of your desktop computer.*

ü

Place your desktop computer on a clean, stable and covered surface to avoid damage to the computer's
case.*

ü

Follow the ESD (Electrostatic Discharge) damage prevention instructions:

o

Hold parts by the edges, away from exposed circuitry when possible.

o

Do not walk around excessively as this promotes static build-up.

ü

The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.

* Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of the computer

under these procedures. The terms of your Sony Limited Warranty continue to apply.

IMPORTANT!

PLEASE READ BEFORE YOU START

Step 1.

CAUTION!

Disconnect the power cord. Failure to do

so can result in damage to the unit or personal injury.

Using the enclosed magnetic screwdriver, remove the two (2)
indicated screws, loosening the chassis panel cover. Rotate the
unit so the panel with the vents is facing you. Remove the panel
and set it aside.

Step 2. Locate the power cable [

1

] and serial ATA cable [

2

]. Proceed

and disconnect these cables from the hard drive.

IMPORTANT! Some

force may be required to initiate removal of the cables. Grasp the cable
connectors where possible and take caution not to damage the cables.

Pull with equal force on both sides of the cable connectors to remove
them.

Step 3. Using the enclosed magnetic
screwdriver, remove the two (2)
indicated screws from the hard drive
bracket.

Step 4. Pull the hard drive bracket
enclosure from the unit in the direction of
the arrow.

Step 5. Using the enclosed magnetic screwdriver,
remove the two (2) indicated screws and set
aside.

2

Screws

[

1

]

[

2

]