SBC comm Efficient Networks 5260 User Manual

Page 13

Installation Guide for Customer Self-Install: Efficient Networks® 5260, Macintosh

Page 12

6-2

Plug the power cable into the DSL modem and an electrical outlet.

6-3

Connect the data cable to your telephone jack and your DSL modem. There should NOT
be a filter between the data cable and the wall jack.

6-4

Connect the Ethernet cable to the Kingston® Ethernet Port or the built –in Ethernet Port
on the back or side of your Macintosh and to the Ethernet Port on the back of your DSL
modem.

6-5

Turn the DSL Modem power switch ON.

6-6 The

Sys, ATM, Enet and DSL lights should all turn solid green within two minutes

• If the Sys or ATM light does not turn solid green, check your power cable. Are you

connected to a live electrical outlet? Are connections secured? Is the modem turned on?

• If the Enet light does not turn solid green, check your Ethernet connections. Are they

secure? Is the Macintosh turned on?

• If the DSL light does not turn solid green:

• Verify that there is NO in-line filter on the data cable from your DSL modem to

the telephone jack.

• Try another telephone jack in your home.
• Turn off the modem, reboot the computer and then turn the modem back on.
• Verify that you are installing your DSL equipment AFTER the “Service

Completion Date” given to you when you ordered your DSL Internet Service.

• If none of these steps cause the DSL light to turn green, please call 877-SBC-

DSL5.

6-7

Proceed to Step 7 by clicking Next on the DSL Modem Setup screen.