Smartek ST-1200 - Manual (Page 8)

HOW TO USE THE SPRAY
Before using the spray feature, check the fabric label for ironing
instructions because some fabrics may be spotted or stained with
moisture.
The spray feature is particularly helpful for removing stubborn
wrinkles and where extra dampening is needed.
The spray may be used with steam or dry ironing.
Simply pump the Spray Mist Button when spray is desired.
HOW TO USE AS A DRY IRON
1. Position the iron vertically.
2. Plug in the iron.
3. Set the Temperature Control Dial to “MIN” position
Refer to the Fabric Ironing Chart in this manual on page # 10.
4. Preheat the iron until the indicator light goes out.
Now dry ironing can begin
.
HOW TO USE THE BURST OF STEAM
The burst of steam feature provides additional steam for removing
stubborn wrinkles. It may be used with steam or dry ironing.
1. Press the Power Steam button to release the surge of steam.
Pressing the button several times may be necessary to prime the
surge system. Wait a few seconds for the steam to penetrate the
fabric before pressing the button again for more steam.
NOTE:
For optimum steam quality, do not apply more than three
successive shots after the indicator light goes off.
- 8 -