Snapper 1691827 - Manual (Page 2)

Section D. Large Frame Snowthrower With Soft-
No Cab.
Section E. Large Frame Snowthrower With Hard
C a b .
1. Drill hole in right-hand side channel, 3”
below auger drive handle and centered (approx.
as shown in figure 4.
NOTE
Hard cab should be installed first before
installing light kit.
Figure 4.
2. Install light with capscrew, lockwasher, and nut
(nut on inside).
3. Install alternator as provided in the Tecumseh
Installation Instructions. Make sure alternator is
installed with wire harness plug at the 3:00
position. Use the appropriate alternator shaft (F,
figure 1) and self-tapping screws
4. Install clip on upright as shown in figure 5 to
prevent wire from interfering with recoil starter.
Plastic ties provided with kit will not be used.
5. If soft cab is used, tuck the right-hand side of cab
around the light bracket
1. Drill hole in the right hand side of
f r a m e , a p p r o x . d o w n a n d f r o m
capscrew, as shown in figure 6.
2. Install light through cab frame with capscrew,
lockwasher, and (nut on inside).
3. Install clip on upright in figure 5. Plastic
ties provided with the kit will not be used.
F 5.