Satco Products CF260E-B - Manual (Page 8)

Heat & Glo • CF230E-B & CF260E-B • 4038-894 Rev C • 11/05 8
C. Frame the Heater
Figure 3.2 shows a typical framing (using 2 x 4 lumber) of
the heater, assuming combustible materials are used. All re-
quired clearances to combustibles around the heater must
be adhered to.
A
B
(header height)
9-3/4 in.
(248 mm)
NOTE: The height that a combustible mantel is
fitted above the heater is dependent on the
height of the front selected. The minimum
height is 1 in. (25 mm) above the front. Fronts
are available 24 in. (610 mm), 28 in. (711 mm)
and 32 in. (813 mm) high for the 26 in. heater
and 21 in. (533 mm) and 28 in. (711 mm) high
for the 23 in. heater.
See Section 6.C. for mantel specifications.
Figure 3.2 Framing the Heater
Model # A B
CF230E-B
in. 23-1/2 18-1/4
mm 597 464
CF260E-B
in. 26-1/2 22-7/8
mm 673 581