SIIG I/O Expander 2S - Manual (Page 4)

4
5. Set JP1 and JP2 jumper settings to the desired voltage
only if your serial device needs additional power
from the serial port. However, most serial devices
do not require additional power. For more
information see Figure 1 on page 2. The jumpers
can be removed if power is not required.
6. To install the card, carefully align the card's bus
connector with the selected PCI slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
7. Replace the slot bracket holding screw to secure the
card.
8. Replace the computer cover and reconnect the power
cord.
9. Connect the 2-port fan-out cable to the board's
25-pin connector. See Figure 2 on page 3 for more
details.
Driver Installation
This section provides information on how to install the
CyberPro PCI 2S drivers.
Windows 95
1. At the Update Device Driver Wizard, click Next.
2. Insert the driver CD, click Other Locations.
3. Type in D:\9x, click OK, then click Finish. (Change
D: to match your CD-ROM drive letter)
4. From the Insert Disk window, click OK. When the
Copying Files dialog box pops up, type in D:\9x,
then click OK.
5. Restart Windows to complete the installation.