Woodstock D3244 - Manual

INTRODUCTION
The SHOP FOX ® Model D3244 Heavy Duty
Wagon makes hauling cargo a breeze with its
high wooden sides.
Check the inventory list below Figure 1 to
ensure all the parts are present. All fasteners
require a hex nut, lock washer and flat
washer.
To assemble the Model D3244, do these steps:
1. Turn the wagon bed upside down and
attach the rear axle and axle braces with
the M6-1 x 16 flat head screws.
2. Attach the steering assembly pieces with
the M10-1.5 x 20 carriage bolt, then insert
the cotter pin.
3. Secure the steering assembly to the
underside of the wagon bed with the M6-1
x 16 flat head screws.
4. Install the wheels on the axles with the air
valves and cotter pins facing out, and
secure the axle caps.
5. Attach the handle to the steering assembly
with the M6-1 x 75 button head screw.
6. Attach the wooden side panels with the
M6-1 x 45mm button head screws in this
order: 1) Left side panel 2) rear panel 3)
right side panel and 4) front panel.
CAUTION—ADULT SUPERVISION IS REQUIRED
AT ALL TIMES WHEN USING THIS WAGON.
Instruction Sheet
Model D3244
Heavy Duty Wagon
Figure 1. Wagon fully assembled.
COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
NOVEMBER 2003, PRINTED IN CHINA.
INVENTORY LIST
• (1) Wagon Bed
• (1) Handle
• (4) Tires
• (2) Steering Assembly
• (4) Long Wooden Panels
• (1) Rear Axle Assembly
• (2) Rear Axle Braces
• Hardware Bag 1
(1) Button Head Screw M6-1 x 75
(5) Cotter Pins
(1) Special Carriage Bolt M10-1.5 x 20
(1) Hex Nut M10-1.5
(1) Flat Washer 12mm
(1) Lock Washer 10mm
(4) Flat Washers 16mm
(19) Hex Nuts M6-1
(19) Flat Washers 6mm
(19) Lock Washers 6mm
(8) Flat Head Screws M6-1 x 16
(10) Button Head Screws M6-1 x 45
(4) Axle Caps